Floor joists – Part II: beams and joists

The setup With the rim joists installed, it was time to install the two double beams. They are 20 foot 2×12’s sandwiched together with 1/2″ bolts and nuts, there are 4 boards in each of them, and they span 40 feet across the house, supported by 5 piers each. There are two of these beams. I decided to install one, then attach all the floor joists to it, then install the second one later. Space is at a premium inside my cabin with all the lumber and osb stacked inside.   When I set the forms for the inner piers … Continue reading Floor joists – Part II: beams and joists

Roof – Part 3: Installing almost everything on the roof

box frame for insulation almost complete The shingle elevator was made out of wood, and it broke after the week of rain weakened it. So I welded a new one. It works better, but I’m worried about the rails it rides, which are 22 foot long 2×10’s. I’ve made a lot of progress on the roof- the frame is complete, the insulation is completely installed on both sides. I had to stop and measure how much insulation I had left- and use the hot wire foam cutter to cut the 9″ thick pieces down to size – they were too … Continue reading Roof – Part 3: Installing almost everything on the roof